Try to run the chimney inside the building for as much length as you can. A tall and warm chimney will produce good draft.

Try to install your chimney straight up and avoid 90 degree turns in the flue pipe and offsets in the chimney.

Make sure that the chimney  is tall enough and its top is clear of obstacles so it can produce a stable draft.

Use a chimney thermometer installed at a distance of approximately 18 inches on the flue pipe above the stove. Flue gases should reach at least 350ºF before you close the stove's primary air intake completely. Operate your unit within the comfort zone indicated on the thermometer.

To reduce the risk of smoke spillage into the room upon reloading your stove, leave the primary air intake completely open for a few minutes. This will heat up the chimney and build up draft before you open the stove door.

Maximize hot air circulation! Our wood stoves are designed to easily receive a variable speed blower that will improve heat distribution in front of the stove.

Remember that wood stoves produce radiant heat. Since heat rises, the use of floor traps will greatly improve the heat transfer to rooms upstairs.

Use a mobile home approved stove if you are going to install your wood-heating system in a mobile home. A fresh air kit must be connected to the stove. Never install your wood stove in a bedroom.

Make sure you have a good bed of red coals before you load your stove with logs exceeding 3 inches in diamater.

Read and keep your owner's manual. It will provide you with tips on how to run a successful wood-heating system.